My Scansnap was being used through a USB powered hub.
This worked....Shutdown EVERYTHING and unplug computer from your powerstrip for 10 seconds (or just turn off your powerstrip for 10 seconds) It resets the BUS power. This solved why almost all of my USB devices stopped working or were behaving badly.
If ScanSnap ix500 connected by WiFi to your PC try the following: just pull the power on the wireless router, leave it for 5 seconds, reconnect power to the wireless router, wait 2-3 minutes for it to boot up again.
SOURCE: My scan snap scanner just
Unplug the scanner and turn off the computer unplug the computer from the outlet. Then push the power button on your computer with it unplugged.
This is a reset now plug the computer back in and restart it do not plug in the scanner yet.
Once logged in plug the scanner back in and power it on. If this does not work then re-install driver for this scanner and the software again. I hope this assisted you. John
SOURCE: I have and love Scan
Check out:
http://forums.macosxhints.com/showthread.php?p=527817#post527817
Thelatest Fujitsu ScanSnap V2.2 L11 drivers have been patched by me to work withS300, S500, S510 and fi-5110EOX/2/3 PC-based scanners for the MAC. Noneed to buy a new scanner. Just apply the patch and then send me aChristmas card! ;)
Hope this helps!
70,040 views
Usually answered in minutes!
×