Stuck on amber light will not turn on

your Main board went bad, common issue with these units. Need to be replaced, in tv land it called main board in computer world mother board. your unit has only two boards power board and that is good cause you get a amber to green to amber led. good luck Vizio field tech

If Try one or more of the following

Ready light does not turn on and the camera does not work.

• Turn on the camera (Turning on the camera).

• Install new batteries (Loading the battery) or charge rechargeable batteries.

• Turn camera off, then back on.

Ready light blinks green.

• Camera is operating normally.

Ready light blinks amber.

• Wait. Resume picture taking when the light stops blinking and turns green.

Ready light blinks red and camera turns off.

• Install new batteries (Loading the battery) or charge rechargeable batteries.

Ready light glows steady red.

• Transfer pictures to the computer (Transferring pictures with the USB cable), delete pictures from the camera (Deleting pictures/videos), switch image storage locations (), or insert a card with available memory (Using an optional SD/SDHC or MMC card).

• Wait. Resume picture taking when the light turns green.

• Change the image storage location to internal memory (), or use a different card.

Ready light is off or glows steady green.

• Camera is operating normally

check your lamp door interlock switch.

when i turn the printer on the light flashes amber several times, then green then repeats flashing amber, and back to green etc. turning it off and back on made no difference. last time it worked normally after being off for a couple of days, but now it is doing that again.

Amber light flashes 7 times, then green for a couple of seconds, then amber 7 times etc.

what error message coming from your computer...i think something stuck inside your printer

Hello:

Make sure u replace the lamp cover as the safety switch need to be closed to make the set work. If new lamp did not repair your problem , then it may well be the Ballast Board, Sometimes call the Lamp Driver.

Red light indicates that the camera is out of charged., Try to charged your battery for 3-4 hrs if you encounter flashing red on a fully charged battery you need to call kodak 1 800 235 6325 ext 12

You can charged you camera using 5V AC Adaptor or a USB cable taht attached into the computer

for your VP50, it could just be simple as a power supply but it could also means more. Do you have the amber LED light when off and green when on? if so, try the main board first. If that doesn't resolve the problem, then change the sustainer boards.

make sure that all the cables are connected FULLY.
blinking light means that there is no signal.

if it turns green that means that it is charged, but it then if it turns amber that means that it is going bad

thanks
hope this works for you