Error code 01 means interrupted heating phase or no heat on final rinse if machine is heating on beginning of wash this will be a blocked transfer hose or pressure chamber need to remove left hand side panel to access and base panel to access transfer hose it will be full of food deposits messing up water fill cycles these machines will only heat correctly when wash water is at correct level. the wash perfprmance will suffer till this is done.
SOURCE: Bosch Dishwasher Model SHU5316UC-06 -- what does
2H is not exactly an "error code", but it does indicate a problem. It means that the machine exceded its wash time by more than 2 hours. This is usualy caused by a failure of the heater, most often caused by a failure of the controll. Remove the control from the door, remove the plastic housing from the control, and check for a bad solder joint on the heater relay.
If you find a bad solder joint, REPLACE the controll.
Or call a qualified service person.
NOTE: The SHU53A dish washer with serial numbers from FD8205 to FD8507 are included in a factory recall. If your dishwasher is one of these contact BSH @ 1-800-586-9226 24/7.
SOURCE: Hi Our Bosch dishwasher (sms63e09uk) has
It means the machine is not getting enough water you need to replace the water inlet valve, that is very possible try cleaning it and see if that helps.If it does
not then the problem is the water valve.Which is a very common problem.
This air flow error code refers to the dryer vent. This can refer to
the dryer's lint screen, the thermistor behind the filter, or the vent
itself could be clogged.
In order to determine which one is the problem we will need to gather some information.
1. Will water pour through lint filter's mess?
2. Outside where the unit vents on the side of the house can you feel air coming out?
3. Is the vent hose on the backside kinked or clogged?
4. Obstruction on vent housing outside (if screen is present on outside remove right away this is a fire hazard.)
Water should pour through the lint filter easily. Fabric sheets will
put a layer of wax on the lint screen causing the dryer air circulation
to be cut off. We should be able to feel warm, moist air at the vent
outside. If air is not present you are in need of a dryer vent
cleaning. A kinked or clogged vent hose can also cause the E01 error
code. Ensure the vent hose is clear and placed in position with as few
bends as necessary. When the vent is clear the E01 error should clear
itself upon start up.
Hope helps.
4,182 views
Usually answered in minutes!
bosch error code 01
×