At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.
Re: Camera temp is too low keep camera power on pls. wait
Stop making your movies in the freezer my friend, try going in doors, Hard Drive cameras are only good for proper temp filming, that is why most proper cameramen still stick to 8mm tapes.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Sir/Mam,
Thermistor 2 has detected a low or high temp. In the fuser the hot part. Mite want to have a tech look at it. clean it or replace it. to reset it once power of the machine from inside leave the power switch on the control panel on. hold down the utility/counter button turn on the machine wait to see trouble reset touch OK then power off wait ten seconds power up if it comes back do not reset again THE machine is trying to tell you there is a problem keep doing it will cost you a lot!!!!
its probibly early signs of condensation or a little damp air with faults of this nature same as lense cap fault and or condensation fault leave camera plugged in and switched on for a week . when camera has been on for a while dont put it straight into a bag or case leave it a room temp for a couple of hours after use before putting it away .
Hi there please reset the camera setting 1st & after that if you face the same problem then replace the camera internal power condensor. Thats must be damaged and can't received the battery power. Thanks & waiting for your feedback.
that is a dew sensor message /mean warm up your cam room temp press eject and get an air dryer
and blow hot air inside for a few seconds ,do not set the dryer at high level /medium or low to avoid damage to the plastic or inside it if that does nt work
you got to replace the sensor in the camera.....
you must be trying to operate the camera in a cold area when the cold gets to the camera it forms moisture leave it turned on until it warms up hope this helps regards Jim
I'm an English guy with the same problem... What you do is keep the power on for a long time, or you charge it up with the charger. Trust me. However, it is very rare for this to occur. There should be a message saying: "Temperature is too low, keep power on." There should be another message reading: "Turn off power and turn on again to check if camera is fully-functional. Thanks for giving me something to do while X-Plane downloads on my Mac OS X.
mine is an everio gz-mg37u and i get that same bulls*** on the screen at every power up. First I tried waiting a while then switching all the switches between camera and video mode, record and watch mode, etc. and one time it worked and the message went away. Haven't been able to do that since.
Now what I do is turn it on, wrap it in a blanket, leave it about 10 minutes, then turn the power off and on again. Works fine for me, and if I turn it off and then turn it back on within a few minutes before it cools down, it works fine. There has to be a messed up sensor in this thing that I can desolder somewhere......
×