REMOTE DIRECTTV Cannot program our remote for AKAI 26 inch plasma and DVD TV, for a remote with Direct TV RC23

You didnt list what brand tv you had so I couldnt get you the exact code.. Here is the direct link for a RC23 remote. Click the link. Type in brand of tv and model number The code or codes should come up and also tell you how to enter the code. Which I also put here..
http://www.directv.com/DTVAPP/global/contentPageIF.jsp?assetId=P4380056#h:1020.659

Setup Instructions

Set the "Mode Switch" to TV.

Press and hold the "Mute" button and the "Select" button until the visible LED blinks twice.

Enter the 5 digit Code above.

Try your new code and tell us how it worked!

10154 is the most popular code for Sanyo. I found it on this page of the directv website: http://www.directv.com/DTVAPP/global/contentPageIF.jsp?assetId=P4380056

White remotes RC16, RC23, and RC24 may not be programmable to some later TV models.

The codes for RCA televisions are as follows

11447, 10047, 10019, 10679, 11247, 11547, 10090, 11147, 11047, 11347, 10018.

here is a link to the DirectTV instruction page for remote set up and instructions if you are unable to find the correct code.

http://satex.com/directv/remote_codes.html

Hope this helps :)

I found these codes for this Akai (in which I'm totally dissapointed) and successfully programmed my DirectTV remote using 11675. Good Luck,

THE CODE FOR DYNEX TV'S USING A DIRECT TV REMOTE IS 10463. THEY ARE AFFILIATED WITH SANSUI. THEY USE THE SAME CODES.

Go here: http://www.remotecodelist.com/remotes/ look it up by type of remote then to the device code...
Bill

Go to Best Buy and buy the DirectTV Universal Remote Control Model RC64 ($20). It will control both the Satellite Receiver and the Olevia TV (Everything on the Olevia except the A-B-C-D Guide buttons). The Remote Control User Guide lists the control codes, four for the Olevia. The codes are:

Satellite Receiver: 00392

Olevia 235-T12: 11610 (last of the four codes listed for Olevia)

Enjoy!

Nick from Ft Myers

Here is a link to your manual:
http://www.directtv-advisor.com/support-files/direct-tv-remote-manual.pdf

Try this: On the Tivo remote press and hold the TV Power button and the Directv/TIVO button at the same time. Hold both buttons down for about 4 seconds or until remote light stays red. Then press the channel up button until the tv turns off. You may press the button over 100 times. You need to go slow. When the TV turns off press the enter button (or select button).

If you have an emerson tv and direct tv the code you want to use is Akai 10812. I sat and went through every code for every tv and this one worked.