I found this on another website and it worked for me. It apparently resets the printer. Hope it works for you:
1.) power on (error message)
2.) press the "Stop (triangle)" and the "Colour copy" button and hold them
3.) press the power button to power off, still hold 2.)
4.) press the power button to power on, still holding 2.)
5.) the LEDs start to flash, then they stop to flash and the red exclamation mark starts to flash. Now release 2.)
6.) the LED should say: "Init EEprom"
7.) now press and hold the power button until the printer powers off and powers on again.
SOURCE: printer displays erro message:
1.) Turn off the power and disconnect all cable connections ( usb cable and power cable ).
2.) Check for any obstructions in side the printer.
3.) While the printer is off and cables are unplugged., press and hold the on button for 10 sec., release after 10 sec., connect the power cable., turn on the power., check if error persist.
SOURCE: It reads Printer Error - see your documentation
this means your printer waste pads are full and the printer needs to be reset for it to work again or it can just be reset
SOURCE: error message says printer error see
found this on another forum. I had the same problem and this worked for the problem posted:
Found this on techsupportforum.com and it worked for me. Good Luck!
Press
and HOLD all following buttons: Power, Load/Eject (I don't have this
button, so I skipped this), Stop, B&W, Color. Continue to hold the
buttons until "Init Eeprom" appears on the printer screen. Press Color
button to clear protection counter.
The panel then told me to press the power button, I did. When it came back up, everything was fine.
SOURCE: Get an error message
I found this on another forum because I had the same problem. This solved the problem and hopefully will solve this error message too.
Found this on techsupportforum.com and it worked for me. Good Luck!
Press
and HOLD all following buttons: Power, Load/Eject (I don't have this
button, so I skipped this), Stop, B&W, Color. Continue to hold the
buttons until "Init Eeprom" appears on the printer screen. Press Color
button to clear protection counter.
The panel then told me to press the power button, I did. When it came back up, everything was fine.
SOURCE: When I turn on my Epson stylus CX6400, it has the
Do you have any other indicators such as flashing lights or similar?
My guess is that it MIGHT be a "service required" error meaning the waste pads are full in which case this guide may help..
There's a reset sequence you can follow near the end of the article which I'd try... If that solves it then you'll need to deal with the waste pads.. If not, you'll know it's something else and can report back..
400 views
Usually answered in minutes!
×