The clasp to connect mask to snorkle broke. can I purchase the small clasp?

Yes. You should be able to find a replacement strap online or at your local sporting goods store, for quite cheap.

mcdevito75 here, Look for any kind of lip on the clasp you can slip a finger nail under to lift, also look along side of the clasp as this clasp may have tabs you simply squeeze to open it. If this fails, simply stop into any small watch repair shop in your area for help.

Just about any local jewelry store can repair this. Just go to the yellow pages in the phone book and look under jewelry repair. I know that Zale's and Clark's Jewelers can repair it. And they should have a new clasp also.

superglue the clasp back together ?

mcdevito75 here, Without seeing the watch it"s hard to tell, but I would figure the clasp could be repaired, but the cost may equal a new band and clasp. Look for a small watch repair shop in your area and compare repair cost of the clasp with that of a new band.

What is the full part number for this? Sears has about 9 letters in their part numbers.

You can purchase clear 2-part epoxy products at most home improvement stores. You will also need masking tape (or similar) a popsicle stick (or similar) a small piece of cardboard and a toothpick.
Mix the epoxy with the popsicle stick and apply a small amount to the exposed surface of the volume control's stem. Holding the knob in place, run a strip of tape from the top of the unit, across the knob and to the bottom.
These epoxies are very strong and fast setting. It's probably best to leave the tape for at least 8 hours but you should refer to the instructions for the epoxy you buy.

Good Luck,
BB

Try to spread apart the clip using two sets of small nosed pliars on each side of the clip, therefore not applying any pressure to the mask. Best wishes with a wonderful sport!

didn't yet. thought this was a free service. thats why i didn't complete. thanks anyway. will figure it out.