I have a sharper image camcorder that was working fine until the screen turned white. Everytime I turn it on it always shows up with a white screen. How can I fix it or reset it?

Probably u dont have a battery for the camcorder or do u ??

Turn it on high. Put a kleenex up to the intake or discharge screen. It will push it away or pull it towards the screen depending on if you are on the intake or discharge side of the unit.

Sounds like the internal battery is too weak to run the device. Let it charge for a while and see if it will turn on after say about 30 minutes.

The Sony has had some problems with the LCD screen since models made about 2004, so if your camera was made since that time.

we changed out the light buld... now it works fine.. funny thing was projector was brand new just out of box... you could see first thing there was a brown spot in the center of the buld creating the spot apparently after it heated up.... thanks again

Hold the "V" button untill it blinks on your screen, then use the "PREV" and "NEXT" buttons to adjust the volume...not that hard....

On the "Alarm" screen click up (the top screen should show not numbers now), then simly click mode until you are back to the "Time" screen.

Try turning it on and letting the battery go dead then recharge to full juice.It should work right again..These things tend to lock up every now and again and to stop it is to run it dead and recharge it...

I’m happy to assist further over the phone at https://www.6ya.com/expert/joe_a3369546f8067589

start with this
http://www.fixya.com/support/r561901-ipod_problems_start_5_solutions

Try Energizer Lithium batteries.

Trevor Gordon
Senior Customer Tech
General Imaging Company
(Exclusive GE Digital Camera Licensee)