Hotpoint aquarius VDT60 fault F-15 keeps

Hotpoint Indesit dishwasher flashing lights fault error codes ...

? 15:08
www.youtube.com/watch?v=FRLbrBPHcnE
May 3, 2015 - Uploaded by how-2-repair.com
http://www.how-to-repair.com/help/hotpoint-aquarius-fdm-dishwasher-flashing-lights-and-there-fault-codes ...

F09 is a module fault. Likely needs replacing.

Please read in full before attempting any repair.

p.s. Before working on machine "turn of the power".
Only carry out if you are confident that you can carry out safely.
Note check small black hose to the air pressure switch is connected,

When machine is turned upside down, the hose has a tendency to come off.
If unsure call a service engineer.

My machine just had the flashing "door" fault.
On carrying out fault finding checks,
I Found that the main PCB had a built up dust.
This dust was in black lines going between components of the board.
Cleaned around components of the board with a small soft brush.
assembled & tested okay 2 months ago & still working.

You may have soap & grease in the pipe that leads to the pressure switch. Remove and flush through and/or replace. dry before refitting.
Thus constant high would give pump faults (thinks machine still contains water). Constant low may cause over filling. If you have a plug that suddenly moves, that can cause the above errors.

Hello
F 13 is a fault code for water supply,inlet valve or hose connections.

You may try unplugging the machine and plugging back in to reset.

sounds like a fault with the presure system

it's a motor problem. could be as simple as the brushes or could be the circuit board at fault.

I have a ultima WMD940 won't drain and comes up code F05. Please can you help my washing is piling up

Hi ya, just a quick suggestion, have you cleaned the filter on the front of your machine?? My machine did this and it was only when i cleaned the fluff and the 5 pence pieces from this filter it stopped, Hope it helps
Dobby

it might be too small of a fuse for your machine