Connon mp730error ##334

Change your drum and clean the developer unit.

You did not mention which lens. Some Canon digital cameras will only take EFS lens, others take both EF and EFS. Also there are other types of lens mounts made by Canon.

Cordially,

If your lens is a EF mount and your digital can take EF lens the answer is yes.

Cordially,

The error code E000000-000 means that you have a problem with the fuser unit. Did you have a power outage recently???? That may have been the cause of the code. Or you may need a new fuser unit... Did you try to rest the error code in service mode?????

you must change your fixing film,you can't rectify it

try turnig it on then diconect the photo printer and then connect it again

Hi there

I would try taking the inks out clean them up with a little alcohol and look at the heads and do same to them, and also gave the all the brass conations a good clean, push them in all back again make sure they are all nice and firmly sitting in, and see how you get on from there.

Hope it will work for you.

Please come back and just gave a vote, it will gave me some satisfaction to know am helping some one so I will keep on helping.
All The Best: Pineworks

Hi there

I would try taking the inks out clean them up with a little alcohol and look at the heads and do same to them, and also gave the all the brass conations a good clean, push them in all back again make sure they are all nice and firmly sitting in, and see how you get on from there.

Hope it will work for you.

Please come back and just gave a vote, it will gave me some satisfaction to know am helping some one so I will keep on helping.
All The Best: Pineworks

Hi,
#334 is an eprom error, try turning it on and off to reset it, if it doesn't work there might be a problem with the main logic board.

ScanGear CS is a TWAIN error