Cuts off printing - Avanquest Checksoft 2005 (00018059034600) for PC

Try [ Ctrl + P ] Control plus letter P key. Same time.

you can maintenance ................. cleaning or deep claening ......click
it is in page set up ................. main........ preferences...

Is this happening with every program you use to print? If it's just a single program, try changing the line spacing. It sounds as if you've got the line spacing too small for the current font and it's cutting off the bottoms in order to print the next line.

Cutting is typically either a command being sent in the print stream from the computer or is a configuration setting in the printer to cut after printing. Also be sure the cutting mechanism is connected properly.

Yes, most likely your application's margin settings are incorrect. Try printing a test page - NOT from the application. If this is Windows, go to printers in control panel, right-click on the subject printer, choose Properties, then click the Print Test Page button. You should get the standard Windows printer test page with the logo at the top and all the printer specifics below. If the test page is also cut off, look around in the HP-provided software for any margin and/or page size settings that are incorrect, such as A4 paper when it should really be Letter size.

Turned off "bidirectional printing" in the printer settings.

The <ESC>m command performs a cut.
To use it, open Printer Properties>Printer Commands>End Print Job and set it to <1B>m

I was having the ame issue. Found the solution on the user manual (posted online). Press Function, scroll to "Margin", press "Function", use arrows to select "#" or "##", then press Function again. Now it should print with a margin, thus not cutting off your letters. Mine was set to "-", which is basically no margin.

Go into printer friendly setup, then select the receipt printer and choose the option 'Cut at this station'. Make sure it is unchecked. Your problem solved ;)

check that the pic is not too big for the print mem if so try changing the port settings to spool or print direct