Sony kdf 50e standby light flashing 2 pulses - Sony KDS-R60XBR1 60" Projection HDTV

Hi,
Yes, if you have not replaced the lamp since you purchased this TV.
Lamps usually last about 6000 hours.
I've seen lamps last much longer than 6000Hrs, it all depends on the usage.
Remove the lamp from the TV and do a visual inspection, see if there's a crack on the glass or the bulb.
If the TV is few years old then the Lamp may be bad.

For a new Lamp: 800 638-3328
https://www.encompassparts.com/
DO NOT BUY the lamp from ebay

Good luck to you.

Nour Sabre
www.tvservice.com

need to replace the lamp to resolve this issue

Hi,
I can help you to solve your Sony KDF-E60A20 tv problem.
Does tv turn back on itself OR standby light start flashing?
If standby light flashing, please count how many times it flashing after three seconds long pause and let me know to diagnose problem.
Thanks.

it seems that u have the lamp door is open , or u have bad safety s/w , this is one that closes when u put the lamp , u need to take the back cover off , for this kine of job is better if u hire a tv tech , because he has to remove alot of cables to get to the s/w

tv works for about 2 minutes, then shuts itself off. the red standby light flashes 50 times, then the tv. comes back on for approximetly 2 minutes then goes off again, only to repeat again

If standby light flash 3 times that means Lamp Cover is open or not fixed properly on its place.
Please make sure lamp cover is fixed securely.
Have you replaced its lamp recently?
Thanks.

Hi,
Seems its time to replace lamp in your Sony KDF-E50A10
When lamp in TV got weak in result, standby light start blinking and if lamp got broken / dead, you will see lamp light ON.
Lamp replacement procedure is easy and written in user manual, please buy Sony original lamp for TV safety.
Thanks.

This is what I found
You may want to have a Tv repair shop look at this .

Standby light flashes 10X

Symptoms / Customer Description
Standby light flashes 10X
[Primary Symptom Code: 2111 ]

Solution

G1 and G2 boards are ok.

Found Q box was causing loss of DTL MODULE 5v.
Replaced Q box to resolve.

Part #
A1058689A

3 blinks means lamp cover error