Can't find manual on line for 33 inch harrow ATV disc

What is the exact modle number to your Bose Changer? If you send this information, along with your email address, I'll send you copy of it if I have in my manual library, by return mail.

hi,
power off and remove from mains. put the arm manually to the center of rotating plater(end of the record) it will stop. from there slightly push the arm to the center little ( do not use more pressure). the take back it to the arm rest. power it on and test it. watch the difference. need more do the same again.
ok

There are 2 types of recorders. Professional, which you can use any kinds of cdr blanks and the Consumer, which requires to use
"Audio or Music only" discs and harder to obtain locally nowadays, but probably plenty on line.

Are you sure the belt part number is not 754-04088?

That is a 33 inch belt. I do not know if you need the 1/2 inch or 3/8 inch wide belt. Pulley size would be the key for belt width. I think it is 1/2. Any local source automotive parts or Lawn Mower supply will have this belt in stock. 1/2 x 33 or 2L 33

If by chance I got the belt part number wrong, (I don't think so) just respond here and we can keep searching for your belt.

Thanks for using Fixya.

Kelly

hi

the 3inch disk fits into the same drive as your cd just place it in the center depression of the CD/DVD drive

as for the disk full error check to see from the camera settings if you have set to save the photos on the camera or on the memory card

cheers
pls rate if it was any help

GET YOUR PC PROBLEM FIXED

http://www.windowsguru.org

Check for leaky capacitors in the vertical section of the TV or cold solder joints.
I would also check in the power supply.
Good Luck.

 

Depending on the type of disc drive that you have in your Xbox 360 console, use one of the following methods:

 

Method A: Insert a straightened paper clip or another small, stiff wire into the first hole from the left side of the disc tray. To release the disc tray, push the paperclip into the hole to press the manual eject mechanism. The manual eject mechanism is a white lever that is visible behind the console casing. The hole is located about one-and-a-half inches (approximately four centimeters) from the left edge of the disc tray.

 

Method B: Insert a straightened paper clip or another small, stiff wire into the second hole from the left side of the disc tray. Push the paperclip repeatedly into the hole to turn a gear to release the disc tray. The hole is located about one-and-a-half inches (approximately four centimeters) from the left edge of the disc tray.

 

Method C: Insert a straightened paper clip or another small, stiff wire into the into the hole that is directly under the "X3" in the Xbox 360 label on the disc tray to release the disc tray. The hole is located about one inch from the right edge of the disc tray.

 

In each case, make sure that you line up the paperclip or stiff wire to pass through another notch behind the hole on the console casing.