How to clean glass cooktop maytag electric Model

did you check the house fuse ?

Your are not quite specific about what kind of a cooktoop ypu want to replace:


DIY How To Replace Gas Cooktop

Whirlpool Cooktop Broken Glass Replacement Model RCC3024

ge electric glass cooktop board glass replacement

Cooktop Main Top Replacement GE Electric Cooktop Repair Part WB62X10047


You can search for more using these terms with COOGLE

Youtube Replace GE cooktop

This should be a double paned insulated glass, you will need to take the door apart to get behind the glass.

I navigated the SCHOTT website to find a solution and was able to find out how to properly clean my SCHOTT stove top. I would check the Ceran FAQ list to see if your question is answered before anything else.

One of the high heat sensors has failed on one of the burners under the glass. Disconnect one sensor at a time to find out which one, then replace that burner assembly.

Hello and sorry to read about your problem.
You might want to think about a new unit. a glass replacement, can run $600.00 to $900.. and more. and that's just for the glass....

I tried to help you.Please help me and vote/rate my response thanks

Yes is a part no 1

Enlarge Photo

COOKTOP
Part Number: AP4360879 made by WHIRLPOOL

$199.78

in the follow link you can find all parts of your model

http://www.appliancepartspros.com/partsearch/model.aspx?model_id=5170740&diagram_id=1333343#d1333343

Yes you can. Call Jenn Air ((877) 232-6771) and give them your model number (serial is helpful too). They sent my replacement glass within a week. I have a model JED8430ABD from 2000 and they had the top. Fit perfectly and took about an hour to replace.

To change it out, after unplugging the cooktop, I removed the metal tape connecting the external vent shaft to the blower. Then I just lifted the entire cooktop out up out of the countertop so I could access the screws on the sides of the cooktop (looking at the edges of the new cooktop glass helped me figure out which screws to remove around the edge). Then I removed the 2 screws in the vent area on top (1 black screw on each side). And that released the cooktop glass from the metal box that holds the burners. I then took the rubber rings out of the knob holes so I could put them in the new cooktop (I almost missed that...). Finally, I put the new cooktop glass on, put the screws back in, lowered the cooktop back into the counter, and retaped the blower to the vent shaft. Voila!

I really wouldn't be afraid of doing this yourself if you are handy at all. And it will save you a ton. Good luck.

PS The screws around the perimeter are hexigon shapped, so you can't just use a screwdriver. I found my Black & Decker electric screwdriver had that same shaped hole that it held the bit, so I just pulled out the bit and used the screwdriver that way. Worked like a charm.

If you can give me the model number I can give you 3 places and there prices. The model number should be located on the bottom of the unit.

We Use Debruce Polish on all our cooktops. Debruce also works on stainless steel and polished granite, marble, porcelain, formica and glass. DeBruce is non-toxic odor-less and eco-friendly. You can get DeBruce on line at debrucepolish.com.