Error code 62 on Brivis Me20 ducted heater - Heating & Cooling

Hi Matthew,
It would seem obvious to contact the manufacturer's customer support department. http://brivis.com.au/

could be broken ducting letting hot air escape or on the intake side drawing too much outside air in. could be the fan unit not pushing enough air

They are correct, the board is bad.

Hi. Here are the error codes for your Brivis Heater. Error Codes 30 - relating to speed sensor, 40 - overheating, 65 - motor lock-out. Usually resetting the unit will resolved the issue. In your case, you already reset the unit and problem came back. This will require immediate attention by Brivis technician.

Hello, We have Brivis Me20 gas ducted heating. It suddenly stopped working and gives error #60. Sometimes after pressing reset several times it fires up for a short period then fails again. Any ideas what might be wrong?
Thanks,
J

I had the exact same problem and called 1300brivis. They told me that the error means the thermister needs to be replaced. My unit is also out of warranty but they are still going to come out and fix it.

On the unit outside there is a button that says "push man. pull auto" if it is set to push man then the fan will go constantly.

brivis wombat 2P 20 ducted heater, gas fires up but fan not starting
Any suggestions...???

These Brivis guys and girls are a rip-off. They are only out to take your money. Then can easily ask you to do just as mentioned above. And pronto all works in 3 minutes to be precise.
It is just the power supply reset required due to a fult being detected, either caused by a very low setting on the controller less than 16 degs. or a higher than 25 degs. setting causing overheating when the damper outlets are mostly closed.
So, put the power supply to heater off first, reset the heater panel, press the button again to shaow EMS on and then set the heater to the required temp. after turning on to the heating mode. That simple! That is if it is the error 71 HI.