Question about Homelite Consumer Products 9.0 Amp, 14 In. Chainsaw
I have a Homelite Model: UT109470 chainsaw which does not stay running. I put in a new spark plug and got it started, used it to cut down a few branches, then it started smoking (due to bar oil running low). I shut it down, filled oil, then started it up again. Cut few more branches and the saw died. While I was using it, it would die occasionally, but started back up.
Since then I tried starting it, but it wont stay running. It would start, run for few seconds and die. I started it today, got it running for a while, but when I release the trigger and push it in again, the saw dies immediately. It also does not sound very good while it's running. Any suggestions????
Thanks in advance!
I have a Homelite 33cc which has never run smoothly since it was brand new. Erratic running, sometimes wont idle, and never seems to develop full power. Adjusting the jets achieved no lasting improvement. In frustration I stripped it down right back to the intake port on the cylinder and found the problem. The two screws that hold the the carb mounting plate to the cylinder were a tad too long in manufacture, and even though done up very tight they bottomed out in their holes before applying proper pressure to the sealing gasket, which then developed some "flutter" in the airflow and partially disintegrated, leaving massive air leaks. No way it was EVER going to run properly like that. Check that this isn't the problem area on your particular model before you go crazy trying to tune your carburetor.
Posted on May 07, 2013
Make sure you are using fresh fuel mix (50:1 ratio). Don't use boat motor oil in a saw--only modern synthetics made for saws. Always premix the oil and fuel thoroughly before adding to the saw. Check the fuel filter for plugging and the condition of all fuel lines, plus the primer bulb condition. Check all carburetor fasteners for tightness. Make sure the air filter and muffler are not plugged. If still no help, you may need to service the carburetor. For an excellent article on Walbro carburetors, go to: http://www.drystacked.com Pay particular attention to the placement of the lower diaphragm and the cover gasket--interchanging positions of them cause many headaches. Adjustment of the two jet screws require a special 'D' screwdriver which may necessitate a trip to a servicing dealer for adjustment. Hope this helps!
Posted on May 04, 2010
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
Tips for a great answer:
Jan 18, 2016 | Homelite Garden
Jun 01, 2014 | Homelite Garden
Feb 10, 2013 | Homelite Garden
May 19, 2011 | Homelite ZR10926 16" Chain Saw
Mar 21, 2011 | Homelite Gas, 20 In. Bar, 46 CC, Chain...
Oct 27, 2009 | Remington Electric Chain Saw
May 20, 2009 | Homelite Consumer Products 9.0 Amp, 14 In....
7,362 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: