How to start my built in web cam - Acer Aspire 55345410 Notebook

You can disable the built-in WEBcam in the BIOS setting.

go to all program from START, and then HP media, and you will see the WEB CAM.
However if your web cam doesnot appear use the manager recovery HP and install the software for web diagram. Otherwise go to www8.hp.com and donwload the software.God bless you

If there's a built-in utility,

1. Open the start menu
2. Type "cam"
3. If a utility comes up, use it.

If not, then there's no built in program to use the web cam. You can use third-party software like Skype to use the web cam for video chat.

The best way to check is to click on Start menu> right click on Computer/My Cpmputer> Properties> Device Manger and check if the webcam is listed in it. If it is listed then the computer has Web cam.

Hello

The easiest way to find your web cam is by clicking on the start page on your desktop screen, You will see a small bar at the bottom of the start page that says "start search".

Type in the word "web cam" into the bar and you will see the web cam logo among the search result. Click on it and your web cam will open and you can start using the web cam

GOOD LUCK

well scince there bulit in theres noting to worry about sit down talk on messenger to your freinds and click show my webcam

I would assume this is a built in web-cam. Normally a web-cam software comes installed on your computer and all you need to do start the software and the web-cam will start. Or you may use this link to get a free web-cam software. http://www.eyespyfx.com/my_webcam_broadcaster.htm
Note, if the web-cam is not a built in web-cam this will work a bit differently.

If the web cam is working normally with other web cam applications but MSN then it's required to configure MSN to use the web cam. Please follow the steps given below to configure MSN to use the web cam.

(i) Please ensure that the web cam is turned ON.
(ii) Then, double click the MSN icon and log on.
(iii) Click on the Tools menu, then click on the audio/video tuning wizard. Then, click Next to start the wizard.
(iv) On the first wizard page, under Camera, click the web cam then click Next.

Performing all the above steps will configure MSN to use with the web cam.
In order to start a video conversation, follow the steps given below after signing in MSN:
(a) Click Action, then point to audio/video.
(b) Then, click start a video conversation.
(c) Select a contact from "My contacts" page then OK.

Look in the manual it may tell you how to use it.
Good Luck.

is this a new laptop