Hi,
Your Eureka Whirlwind 4388 takes Eureka Style "U" Belts, Part number 54312.
Here's a direct link back to that belt on our website if you need to purchase one:
http://www.govacuum.com/1541.html
Feel free to ask further questions by using the comment field on the repair page.
Thanks,
Chris J.
GoVacuum.com
SOURCE: How to change belt on Eureka Whirlwind
On the top cover, there are holes at the front on both sides, there is a screw on each side in one of the holes. Take the out, and the cover should come off, then you can get to the brush roll and belt.
SOURCE: eureka whirlwind light speed
Wish you had given your model number, but most of these, there are 2 screws on the top cover, near the front, remove those and the top comes off, the belt and brush roll are exposed.
SOURCE: eureka whirlwinde litespeed vacuum - model 5841
very simple under all three screws in the front (two on sides and one in back) once open--you can take off that panel...take brush out...take old belt out...put new belt on..around brush..place both inside...and make sure belt is around that little pole thing towards the back close panel, replace screws
SOURCE: Need user/owners manual for Eureka Whirlwind Big Cup model 4686
hello chris. here is the link to use to get your downloadable manual
http://www.eureka.com/owners_guide.jsp
SOURCE: how to change belt on eureka whirlwind
You will first need to remove the hood to gain access to the belt and brush roller. Turn the machine upside down, place the handle on the floor and the base on a counter. You will find several screws that hold on the hood, remove them. Turn the machine back to the upright position and remove the hood. On the right hand side,if your looking the front you will find where the belt goes. At the back you will find a silver shaft sticking out, put the new belt on there first. Then put the brush roller through the belt so it is in the carved out section of the brush roller. Then grab the brush roller by each end and stretch the belt till the brush roller fits back into the base. Turn the brush roller 3 compleat turns backwards and 3 forward to seat the belt in the proper position.
Then put back on the hood.
496 views
Usually answered in minutes!
×