Hitachi CP R555 Multimedia LCD Projector

replace the lamp then reset it, http://www.hitachi-america.us/supportingdocs/forhome/DisplayTechnologiesGroup/lcdprojectors/SupportingDocuments/cp-x445_users_manual.pdf

There will be a panel that holds the lamp module in, usually on the base of the unit. Once removed the lamp is usually held in with two screws mounted on the body of the lam. Once replaced, ensure the lamp is correctly fitted and the panel then switch on and reset the lamp life in the settings menu.

Good luck, hope I was of help to you

lamp ballast and/or power supply is going. the ballast has to boost the charge up to 140 vdc, and after it's up to it full strength, it drops down to 40vdc to maintain. if the ballast can't get up to the proper voltage, it shuts down. or the lamp itself will not hold the voltage, and therefore needs replacing.

Specifically i don't know. What i do know is mfg's use the same codes, whether they map them to the same functions across a series of remotes can't say for sure. Experiance tells me it will be just fine...

hold rown reset on panel for about 3 seconds, wait for display, press reset again and select 0.

make sure you reset the lamp timer. Manual has the steps. Hitachi Performa CP RS55 3 LCD Projector

if the timer is reset, try cleaning the color wheel. Optoma HD20 Projector Cleaning this video is for an optoma but the color wheel is cleaned the same way in most DLP projectors. Dirty or dusty color wheel sensors cause the projector to shut down and act like its the lamp.

Hi Jenrowe

Try resetting the lamp and filter timer , if this still occurs reset the whole mashine.

If you do not have a remote here is how to reset the filter time. Use the "Menu" bottun to get the "easy menu" to display. Push the down arrow until you get to "Filter Time," then push and hold the RIGHT arrow to reset the filter time. DO NOT try to reset using the "Reset" option on the easy menu, it will not work.

Hi there

Check if both your filter timer and lamp timer is reset.

If it is then there is a Mainboard fault and it will need repair or replacement.

clean filter and reset the filter timer by advanced options filter timer and hold reset till menu shows then arrow up and it will zero out.