Problems with my hcm5525w projection TV

This model of Samsung is a CRT based projection TV that usues no color wheel : (

change crt coolant on blue and maybe the red if he`s contamined.

If you are using component video cablesm make sure the blue is connected from tv to source.

hello i have a jvc 52" made in july 2004 replaced bulb twice under warranty plus replaced ballast board in 2005 replaced bulb dec 2008 my tv was before and after install having a blue hue reversed words

you need to replace the convergence board.

http://www.partstore.com/Part/Samsung/Samsung/AA9501846D/New.aspx?ModelMfgName=Samsung&ModelBrandName=Samsung&ModelNumber=HCM5525W

If the red gun stops working it could make the picture very blue-greenish. This could be caused by a number of problems, including a coolant leak, but it's most likely a bad electrical connection somewhere in the set.

Best left to a professional repair guy, frankly.

1)Please verify your model # from back of set......

2)Reduce the color to minimum or tune in a black & white chan.
you should see gray, not yellow hue

3)Remove lower front grill cover & access panel.....locate the
focus / screen control block...turn blue screen control slightly
CW......red,green and blue must mix to equal gray

4) reset color to normal level.......reassemble

Most likely a CRT coolant leak onto signal pcb.Look for wet
evidence........T.

Yes you have a problem in the red crt driver board. Most likely the driver transistor is failing. This is a component level repair, so if you have no experience with TV repair, play it safe and call in a trained tech to assist you in this matter. Good Luck

sounds like 2 different problems here. first problem sounds tuner related. second sounds convergence related. third issue (cost effective to repair ?) at this point i would replace the set. i hope this helps