#1 THE FAT PART OF YOUR SPRING GOES INSIDE THE FAUCET ,AND SIT ON THE VALVE BODY(SEAT)
#2 THE LITTLE BLACK WASHER SIT ON TOP OF YOUR SPRING
#3 PUSH THE STEMS IN THE CORRECT SIDES HOT ON LEFT.CAUTION THERE IS USUALLY NOTCHES ON THE SIDES OF THE STEMS TO HELP YOU ALIGN THEM IN THE VALVE BODY,
4 PUT THE NUT BACK ON ,TIGHEN SLIGHTLY,TURN ON THE WATER TO CHECK ,IF OK RE INSTALL YOUE HANDLES
You don't mention the small white plastic piece that goes inside the spring. how does it fit into the spring?
Thanks Mark, and you too Kurt for your question.I missed the little hex screw at first because the stem slipped right off and that's why it wouldn't sit right. I did #1 and #2 correctly. I set the cartridge wrong the first time because the handle turned backward rather than forward so I rotated it. It leaked when reassembled, with and without that extra white piece. It's the hot handle so at which angle do you align?
Thanks Mark, and you too Kurt for your question.I missed the little hex screw at first because the stem slipped right off and that's why it wouldn't sit right. I did #1 and #2 correctly. I set the cartridge wrong the first time because the handle turned backward rather than forward so I rotated it. It leaked when reassembled, with and without that extra white piece. It's the hot handle so at which angle do you align?
×
1,885 views
Usually answered in minutes!
×