My 32in polaroid tv completely lost power/no indicator light, totaly no power

How long have you unplugged it for most TV's have a battery back up which you will have to wait for it to power down after unplugging could take up to 24 hours they do this to keep settings in case of a power cut

You can reset the unit by unplugging, wait 30seconds to 1 minute.then try again.

If still doesn't come on, the lightning may have done some internal damage, such as to the power supply or Main PCB.

Your model is a LCD flat panel which doesnt have a lamp. Instead they have a series of flourescent tubes behind the Screen which light the screen. The backlights hardly ever fail its usually the Inverters which fail when you dont have any picture with that model. You can get the inverter board and free technical assistance from www.tvrepairworld.com

Try polaroid website itself to down load and print it ur self,if ur tv model still in the market.Or call their customers service phone number pay a fee.They'll sent it to u.Try website like Remotes.com to buy an original remote.

Yes,it repairable.The tv have power at all like the LED power light indication flashes?Yes,tries websites like Shopjimmy.com,Ebay.com to buy a refurbish power supply board for the replacement.No power LED light indication all.The power supply board is dead and also the Tuner signal board is dead.Must replaced both boards.

My 32in hdtv turns on, flashes Polaroid and shows there is no signal then turns off, what could the problem be?

check the fuse right next to the plug on the set if thats not bad then your power board has bit hte dust
that model has so many differant supplies it is hard to say what diode has gone or wheather it is just a bad puffy capacitor

is the status light on wheather red or blue if eather one then the fuse is fine if not check the fuse. if the lights are on then chances are your caps are gone its a huge problem with these tvs. if it is your caps than just replace them as i did and the tv is working like new again. These are the caps I replaced they where only a little swollen I was worried if they where even the problem but I changed these three and was very happy that my TV is now working like new again the two top ones I replaced with 1000uf 16v the lower one is 1000uf 35v ok well I hope this helps ya

32 flat panel polaroid will not turn on