After booting, displays the message, is "verifying image"

Have you tried connecting an external monitor.

A boot chime means the Mac has passed POST, that the screen remains black initially suggests there is a problem getting image to screen which could mean a bad cable to the LCD or the LCD display its self is having problems.

By connecting to an external display you verify the graphics on the logic board is functional, and it could get you up and running till the display problem is fixed.

Also try powering up and when you hear the chime, hold down the COMMAND+OPTION+P+R keys, and keep holding them till the machine has chimed 3 times, this will reset the 'BIOS' in case there is a glitch there stopping the display from showing up.

My laptop compaq CQ58 does not start up so it gives me this message selected boot image did not Authenticate. Press <Enter> to continue. If l press continue it switches off, Pliz help wat should l do

I think,you should use operamini browser for that or ucbrowser is the best one in such cases.just try it...

Here ya go!
http://www.tinyempire.com/notes/ntldrismissing.htm

It's not necassarily an error when that pops up. It usually depends on the Motherboard. I know that Biostar P4M80-M7A / P4M800-M7A all do that on their own but will boot just fine after that message goes away. It's offering you an option to boot from a cd. You can change it to silent boot in BIOS if you don't want that message to appear.

First, verify that it's a genuine message and not a spam message that could direct you to a virus. If you know the sender, it should be OK. Generally you can't open a picture message because the pictuire format cannot be displayed by your phone or the image is too big to display on your phone (e.g. the picture format is .gif and your phone can only display .jpg etc.). In cases like this, they usually give you a code and direct you to a website to recover the image. Another cause could be that your phone is not set up correctly to receive MMS messages. Details for setting up MMS and other settings will be available either from the manufacturers website or from your network service provider.

Use an external monitor to verify that your laptop is booting up. If you get a display on external monitor and not in your built-in LCD, you have 3 possible problem, 1st - bad LCD panel, 2nd - bad inverter, 3rd- bad CFL. In any case, it is easier to just replace the whole LCD assembly. You can find used and cheap ones at www.ebay.com

you should have been attacked by virus problem...and you have installed a pirated version of windows i suppose..install an original antivirus software, get your desktop cleaned..this is will be a good solution..feed back pls

hp4250 printserver it was hard drive on server giving boot image 32 errror

a yellow line is comming on both sides of the printout when i print using my phaser 7700