Canon ip4300 printers

There is many reasons for that,
are you printing any thing???

Just restart the printed and see if lights turned off....

Hello, the error you describe is for a faulty print head. When the printer is on open the cartridge acces panel, remove all cartridges, remove the printhead and check the printer and printhead golden contacts. If they are dirty clean them with alcohool (make sure, when you clean the printers contacts, the printer cable is pluged off the power). If that dont help you will have to change your printhead (more than 100$).

Please reset your printer. Check the mechanism for jammed and restart.

Orange light flashes if there is any issue with the printer. Please check all the hardware is functioning properly. Check if there is any paper jam. If printer cartridge is installed properly. Printing head is ok.

Hi there,

A possible paper jam has happen on the unit. Did you have an paper jam error before you have this problem?

You must clear any paper jam on the unit, check the unit for any stuck paper or object or check if there was misaligned parts inside.

Let me know for any clarifications.

Thank you for using fixya.

micro-

Try keeping the paper only in the bottom tray (there's a tray in the bottom) Try pulling any paper out of the top and just close that top tray. Open up the head so that u can see the ink cartridges and turn the printer on and off and maybe it will center itself again. If it's still not working (even if lights aren't red and print head wont align in the center) try manually moving the head back and forth like 18 times so you can lubricate that rail in the back that's holding it. After that, re-turn it off and on again.

That is a "general" error.
Please note that the power LED is flashing you a message (blinking green and / or orange).
Like green 3 times.... or green/orange
Please comment what the light is doing...
Or go to canon and view the possibilities:
http://www.usa.canon.com/consumer/controller?act=ModelInfoAct&tabact=SupportDetailTabAct&fcategoryid=257&modelid=13528

These printers are FULL of very sensitive sensors, and chances are that one of them may have a small piece of paper blocking them. If you can get the covers off by finding the "Triangle" arrow markers, you can inspect all these sensors.

Good luck!!!

Hi Hooboo

There is Canon Pixma ip4300 resetting software available on the net.
http://down2.driversdown.com/Printer/ip4300xp195ea23z.exe