My flash drive was working perfectly until I tried it with another PC after that I returned to my PC and can't detect anymore, there was not light signal unlike before. Can I possible revive my flash drive?
yah my usb flash drive is working perfectly last night on my computer
this morning i try to plug it to my office computer
and what a surprice its not working
no light and cant detect by computer
***********
I have the same problem with 2GB DT Kingston ,
but it may lighted and usb2 called it as Unknown usb device??
helppppppppppppp
[email protected]
Is it several times that youve used your flash driver at your office?
and which side of the usb port did you plug it? coz when it is your
first time to use your flash drive at your office and your plugging it
at the front side of the PC. well there might be something wrong with
connection and may cause damage to the board of the flash drive. if it
your using it several times, well try to check at your PC, then do the
following specs:
my computer (right click and select manage)
and under manage window ( select disk management )
try to see if your flash drive registered (you can see the drives of
your PC) and see if theres a volume (either raw/ or theres a partition
on it).
if not, well the board of your flash drive might be damaged, mostly
these were caused by the power of the system, fluctuation is one of
them, then improper plugging of the flashdrive.
327 views
Usually answered in minutes!
My flash drive was working perfectly until I tried it with another PC after that I returned to my PC and can't detect anymore, there was not light signal unlike before. Can I possible revive my flash drive?
my usb flash drive is working perfectly last night on my computer
this morning i try to plug it to my friends computer
and its not working no light and cant detect by computer
×