Led d1 and led d2 lights are off. I have double and tripled check to make sure the cpu was correctly installed. I have the 4 ph lights on but the led d1 and d2 lights blink on and turn off. Any ideas

I suspect you have a broken clutch drum or stripped splined shaft inside of the transmission. Even if the electronics failed you would still have 2nd, neutral, reverse, and park so the problem is most likely mechanical. Odds are pretty good that the transmission will need to be removed and repaired or replaced.

The amp has 7 LED's in total 4 whiteLED's provide back lighting
the bi-colour LED white/ amber is the power/standby indicator (amber when amp is in standby mode)
The two red LED's are on the Phono Board and form part of the phono amplification circuit.( D1 & D2)They are NOT fault indicators and should be lit during normal operation.

bad inst. cluster

Try the following.
1. Remove battery and plug in the AC Adapter and check if it works
If yes - Battery is defective
If no - Motherboard Problem/AC adapter

2. Check the AC adapter LED indicator if its lighted or not(double check by a multitester)
If lighted - it works properly
if not - replace
3. Try to reinstall WINDOWS operating system by the use of the installer CD
4. Reformat your computer and install necessary drivers and applications

Thanks. Cheers!

D1 is the first date given D2 is the second date given Df is the future date Dt is today's date expression is then---- D2 - D1 = 70%(Df - Dt) Solve for Df and get Df = Dt + (D2 - D1)/.7

have you checked the output on the power adapter when you plugged in? if not, there is no hard reset for the drive. you just have to isolate the board on you external hdd.

not sure what your asking but if the wrong lights are staying or or not coming on it is because you placed the LEDs on incorrectly. check your manual for the configuration and verify that when you place the connector to the board you have the polarity correct. LEDs are polarized and the electricity can only go one way to make them operate correctly

CW Keys 5C01 updated 08/10/09 10:35

00= C5 BE AF 36 0A 61 91 AA
01= D2 D1 80 FA 21 85 0F 53


TW Keys 5A01 updated 08/10/09 10:35

00= 83 5D 12 B8 96 F6 1F C4
01= D2 F9 35 22 0C A7 D6 C9


NTL Keys 5401 updated 08/10/09 10:35

00= F0 0E 91 E0 2D C1 C5 FD
01= 5D 61 B2 C8 E7 DD F9 57

You should have told me you are missing a manual. If you dont follow thing from it correctly, you can really burn your motherboard. from the usb connectors on the motherboard
you see pins like this 1 is set 1 and 2 is set 2. you see those are wrapped in sets from you cable near the end. dont mix them

ooooo 12345
oooo 6789

lets put it this way

vcc1 = 1
-d1 = 2
+d1 = 3
GND1 = 4
nothing on 5
vcc2 = 6
-d2 = 7
+d2 = 8
GND2 = 9

Replace the cpu or ram.