The Harmony 890 turns the TV on and off, but it does not do the other functions.

Hi. Try learning the power commands for your Vizio TV from the original remote. The power commands that the Harmony remote is using may not be correct. The following tutorial by Logitech will assist you with this.

http://logitech-en-amr.custhelp.com/cgi-bin/logitech_en_amr.cfg/php/enduser/std_adp.php?p_faqid=9605


Regards,

D

To check to see if your device is controlled by a RF (radio frequency) or IR (infrared) remote:

Power the device on manually

Cover the front of the original remote that came with the device with your hand

Press any button on the remote that you know the device would respond to normally

If the device responds even when your hand is covering the front of the remote, the remote is RF and the device cannot be controlled by the Harmony remote


Another test that can be performed is using digital camera:

Using any digital camera, even one on a cell phone, camcorder or webcam, look through the screen of the camera at the front of the remote

Press a few buttons on the original remote

If you see flashes of light as illustrated, the remote is IR and the Harmony can control it. If the remote does not flash, this original remote is an RF remote and the device cannot be controlled by the Harmony remote

For comparison, try the same steps with a remote control that you know is working correctly, such as the original remote for the TV, or DVD player. You should see the IR emitters flashing when performing this test.

You DirecTV device may have been reset ack to RF. You'll have to make sure the device is set to accept IR commands in order for the Harmony remote to work on it.

This link will help you.

http://logitech-en-amr.custhelp.com/cgi-bin/logitech_en_amr.cfg/php/enduser/std_adp.php?p_faqid=12985

-D

try doing a firmware upgrade after booting your remote in safe mode

Google this out there will be response

Pull the battery out and re-insert it, also update the remote firmware