How do I remove the powder draw from the aquarius wml520, please?

www.hotpointservice.co.uk/manual
www.hotpointservice.co.uk/help-and-advice/faq/laundry
Their will be a valve or flap that is opens at the correct time
that is now no closing completely.

Timer may be shot.

I've just taken the top off mine, unscrew the 2 screws at the back then push the front with the palms of your hands rearwards, it takes some doing and you may need to get your fingers underneath the lid at the back and just give it a good pull!!

Try removing the draw and cleaning it thoroughly i would recommend running a few hot washers with no powder through the machine too.
Thankswww.TalkAppliance.co.uk

Hi

This issue usually occurs due to kinked drain pipe, clogged drain filter or drain pump. First make sure that the drain is not clogged and remove clogs if present. If no visible lint is present then remove the lower front access panel to check the drain filter and drain pump for any clogs, you'll need to clean the drain filter and drain pump completely. Hope this helps... Please post back for any further assistance.
Daniel

Check level of machine as may be leaning slightly forward. Use front feet to adjust to level or slightly lifted at the front. This will compensate for any slight buckle in the plastics on the drawer compartment.

You need to clean the filter.
Remove lower rear panel of washer.
Remove large black hose fastened to bottom of drum.
Remove and clean the plastic filter inside hose.
Remove hose onto pump, and check for blockage or obstruction here as well.

This should solve the problem.

Remove lower rear cover of washer, locate and remove large black hose, remove and clean filter inside hose.
Please rate my solution.
Thanks.

pull the draw out as far as it will go, there is a blue tag in the middle to the back of the draw, push this down and pull the draw all the way out

Hi
The hose from the drawer into the tub is blocked or kinked, not allowing the water down quickly enough