The power won't come on. Is there a reset switch or do I need to buy a new one?

A new power supply will probably fix this. Make sure to get the same voltage (current can be higher).

did it short out or are you using the correct voltage?

Things to check first for a camera that won't turn on are battery contact points, and micro switches that are located on the battery and memory card doors. Troubleshooting tips on other things that need to be checked may be seen here. These tips won't work for every case, but they're worth a try.

hi i think if you let it repair it cost nearly the amount of new printer, i suggest buy a new one

it is most likely broken. You might think about buying a new one

Check the kill switch rock it back and forth to be sure it is making contact. Open it up and spray it with contact cleaner that is safe for plastics available at radio shack. After sitting for four years I would start with the fuel system. New filter and NEW GAS and check the fuel lines for cracks and leaks. I have seen bikes that sat for 6 months and needing the carburetors cleaned and reset.

hi, what type of batterys have you brought as most normal batterys you buy wont even switch the camera on you need hi power batterys such as lithium or even better go into a camera shop and they will have special high power bats, normal bats wont even switch mine on so give different batts a try

let me know how you get on or if you need fyrther assistance ok

Have you tried the reset feature, small button near the power port.

Hold it down for thirty seconds with the unit unplugged. If that doesn't work you may need to buy a new router as something may have failed some time ago and just not been noticed until it was turned off.

Try the reset, but I suspect whatever killed your modem likely killed the router at the same time.

Hope this Helps FixYa,

Chris