Hello
"You can fix the error code H07 with a little oil on the motor spindle."
or it could be due to a firmware fault...
To check firmware, on player, hold down PAUSE and OPEN, then press 7 on the remote. The last 3 numbers is your firmware.
sorry to say
when i was searchin for the erroe code h07...
i ended with this...according to this the player wont play DVD+R it becomes slow....and it is a piece of junk...
see this following link...
http://www.audioreview.com/cat/home-vide...
just give it a try
the motor spindle is placled just below the place where the dvd rotates on....
if it not works to the maximum just try to replace the motor and check it out...
thankyou..
goodluck
dont forget to rate the solution..
happy FixYa..
×
134 views
Usually answered in minutes!
thank you johnychel I will try the suggestions. what is firmware and how hard is it to oil the motor spindle and where is it.
thanks again johnychel. the news about this panasonic DVD player doesn't look good. panasonic should be ashamed for sell this junk. what would you suggest, to junk it and buy a new one. your advice would be greatly appreciated
PS Excellent help
×