How do I set a LaCrosse WT-961 (B) watch?

Purchase some contact cleaner either online or at an electronics store. Remove the back from the watch and then drip the contact cleaner onto the contact side of the set buttons inside the watch. Then depress the set buttons repeatedly to work in the solution. You may have to repeat a few times. By cleaning the contacts it is likely the set buttons will work again.

Go to WT(World Time) function (down-left button) ,find your actual time city and choose, by pressing the upper-left (SET) button for 2-3 seconds, between DST (Summertime) and Blank (Normal Time).

Hi,

The display of your watch may "freeze" due to static electricity or recent battery replacement.

If this occurs, press and hold all four buttons at the same time.

This will erase the data in the memory and allow you to reset the watch to the factory settings.

Press and hold all four side buttons at the same time to reset the watch to the factory settings.

Hope this helps.

there is reset button beside the battery or you have another option is to push all the buttons of your watch to reset and you can now set the time, date and other that had to be set manually..

Hi,

Hope this will helped you fixing the time of your Citezen divers watch. Just foolow the instruction below.

Change your Citizen watch's time zone without actually moving the clock hands. On the digital display, change the city that displays on the watch, which sets the time to the different time zone. The Citizen also has a calendar, timer, chronograph and LED lights. Since it is an Eco Drive watch, it is solar powered so you never have to replace the batteries unless its backup power source dies.
Difficulty: Easy Instructions

1. Pull the setting knob (crown) out one "tick" for setting mode.
   

2. Set the mode hand to "WT-S."
   

3. Pull the crown out one more "tick."
   

4. Press the top button on the right side of the watch for the city setting mode.
   

5. Press the lower button on the right side to "SET" the city.
   

6. Turn the crown to select a different city, which changes the time zone.
   

7. Push the crown all the way back in to finish setting the time.
   

Thank you for using Fixya.

Hi, I had the same problem and was able to fix it by reading the manual:

Basic Settings for the chronograph hand -
After changing the battery, or in exceptional circumstances, following incorrect operation, it is necessary to reset the Chrono indicator to zero (starting time).
- Leave the winder in Position 1 (pushed all the way in)
- Press button H (top) and button I (bottom) at the same time
- Now set the 30 minute (small hand) counter to zero by pressing/holding button I (bottom button)
- You can now set the 60 second counter to zero by pressing/holding button H (top button).

This worked for me... it took me a while to figure it out, but that

Go to http://www.lacrossetechnology.com/support/setup.php and choose your watch from the drop down menu.

Unfortunately they do not have any instructions but there is a contact address there where you can get help.

I found and pressed the reset button with a tiny screw driver. After about 10 attempts, I pressed the function side button and found that date and time displayed temporarily while holding button down.

Finally after more reset attempts, the time did display.

Actually the sweep arm can be set to 0 and will probably have to be every time you have the battery replaced. To set the sweep arm pull the stem and crown out to the first or second set position then press and hold down the start button. The sweep arm will move into position and you can let go of the button when it is where you want it. Make sure to set the right time and replace the crown in the time position.

Great watch!!

Go to this site below and print out the manual. It gives their recommended way of doing it. If that doesn't work, it even gives a phone number to call and email address to write to..

http://www.lacrossetechnology.com/967s/manual.pdf