How do i remove a jenn-air built in wall oven? (older oven model W131B)

Do you know the oven door fit on my stove F-166

I need to purchase light bulbs for Jenn-Air Electric Double Wall Oven model # JJW9830D

28" High
24" Deep
30.5" Wide

from tech support

this is what you most likely need. Age, or the clean cycle, can cause them to start to malfunction.

http://www.repairclinic.com/SSPartDetail.aspx?s=t-W131B-%3d%3di1364&PartID=1364

It is inside the oven, and comes out/goes in pretty easily, but you have to be careful when removing the old one, not to loose the wires in the hole, because then you have to pull the unit out from the wall and remove the back in order to plug the new one in.

Yes, I just had same problem. The probe receptical is on the right inside wall of the oven. A little flapper door is secured by a single phillips screw. Remove this screw and the flapper door. Gently remove the receptical and its attached cable adapter. With your screw driver short the connector extension to the housing, just as the probe would. This should reset the meal temperature sensor. Try the bake and problem should be gone. If not permanently short this connection with a wire. You won't be able to use your probe, but the oven will work.

The JennAir website should have the installation manual for download. Go there, type on your model number, and it should come up.

Sometimes these ovens just get "stuck" in place, and take some easy levering to break free, or to help you find other fasteners.

I had a simular problem looking for an older model for my mother. You might want to try this web-site address I found. http://shared.whirlpoolcorp.com/product_literature/search_results.jsp?searchTerm=JJW8530C&siteCd=JA_EN_US I hope it helps.

We have a W245 self cleaning oven and the woven gasket is falling apart, can we purchase a new one to replace it?

Big oops, Millwood. Shut power to the unit immediately and wait a day or more for it to dry out. If it works then, fine. If not, you've got a learning experience installing a new pad.

is it showing a code like f8 or any f code