Clean saner then
if
its not solve your problem check exposure lamp harness connections;
adjust the position of contact glassshading plate or clean/replace the
scanner home position sensor;replace the exposure lamp or inverter pcb
if needed; replace scanner board or engine board
1. defective exposure lamp or inverter board
2. incorrect shading position
3. poor contact on connector terminals
4. defective scanner board or engine board
Click on this link or copy and paste the complete link into your browser.
If I could be of further assistance, let me know. If this helps or solves the issue, please rate it and give a testimonial for my response.
Thanks, Joe
I’m happy to assist further over the phone at https://www.6ya.com/expert/joe_8b8c2cd6ce148309
261 views
Usually answered in minutes!
×