Tumble dryer wont dry

If your Grundig tumble dryer is taking a long time to dry clothes and not getting as hot as it used to, there are a few things you can check:

1. Clean the lint filter: A clogged lint filter can prevent proper airflow and cause the dryer to take longer to dry clothes. Make sure to clean the filter before every load.
2. Check the vent hose: Make sure the vent hose is not kinked or clogged. A blocked vent hose can also cause the dryer to take longer to dry clothes.
3. Check the heating element: A faulty heating element can cause the dryer to not get as hot as it should. You can test the element with a multimeter to see if it is working properly.
4. Check the thermostat: A faulty thermostat can also prevent the dryer from getting hot enough. You can test the thermostat with a multimeter to see if it is working properly.

If you have checked all of the above and the issue persists, it may be best to contact a professional appliance repair technician for further diagnosis and repair.

Condenser dryers are simple in operation. They use a heater element to force hot air to heat the clothes and turn the water to steam. That steam is turned back into water by drawing cold air into the machine and over the heat exchanger unit and into the drum. The problems with them is that they are slow to dry.

Your best bet is to call for service, and the problem is likely the sensor probe or one of the thermal cut out.

https://www.4candy.co.uk/tumble-dryer/ro-h10a2tce-80-31101805/catalogue.pl?path=111515,111515&model_ref=14378839&page=2

..

how to fix my t622cw because the drum will not turn round

Hi,

If your dryer is not drying like it once did or if you just have nottaken the time to give yourself a clean dryer in a long time then youneed to do that. At least once a year the dryer cleaning should takeplace. Lint build up in the dryer duct is one of the main causesfor your dryer to fail.

Here is the rest of this tip about DryerMaintenance

heatman101

Broken or belt has come off. If can open back and fix or replace. You may need to remove the top. Careful of the heat element, lift out drum and place new belt on motor holding it while you put the drum back keep hold of belt and place around drum replace top and should be ok. Hope this Helps

You need to check if the belt is o/k.
Remove top cover, and grasp belt, it should be firmly wrapped around drum.
If o/k, then could be a motor problem, or programmer fault
Once you have got the drum turning again, it is possible the filter light will go off,if not, then you have another fault
Hope this helps.

your heating element could be burned out...or a thermal switch could be stucknot allowing the element to turn on

Either dryer element has failed, thermostat for drying or the drying condenser fan not working.

There are two heating elements and the top one is for drying.

my tumble dryer drum wont go round

this will be a problem with your thermostats 1 of them will have a thermal cut-out switch built onto it this thermostat needs replacing it is faulty