Codes need code for for remote control dish network 103602 for magnavox tv whit dvd .

Try Philips, Gateway codes for the Maxent TV

Magnavox DVD codes 527, 533, 556, 554 or visit the website, where you can find the correct model of remote and codes. mydish.com
http://www.mydish.com/support/apps/remotecodes.aspx

jose_luis_es,

I have listed the steps below to address the remote to your TV! I have also included the top 5 codes that work in case they are needed.

Codes: 500, 837, 627, 090, 185

1.) Press and hold the clear TV button until all mode lights light up.
2.) Release and TV light will be blinking.
3.) Enter the code and press #. The TV button should flash 3 times.
4.) Try functions (Volume, Power, etc..) and see if it is working.
5.) If no function, repeat steps 1-4 with another code.

Let me know if you need additional assistance!

Tommy Faust
DISH Social Media Representative

rca tv with a remote 103602

Hi there! In order to be able to provide the definite codes that will allow you to program your remote to your Magnavox Blue Ray DVD player, I would need the type of remote that you have- this can be found on the back of your remote, it would be displayed as something along the lines of 3.0, 4.0, 5.0, etc. To obtain a few codes that will likely allow you to successfully program the remote I used 5.0 because it is a common remote that is used with quite a few of our DISH Network receivers. The codes you can try for your DVD player would be, 829 (most successful) if not then please try the following, 685, 533, 554, or 556. After trying those codes if your attempts are still unsuccessful you can also check the manual that came with the DVD player from the manufacturer or just contact us here at DISH Network - although I do know sometimes the remote codes can be located in the manual. Hope the codes help & work for you!

-Kirstie DISH Network

The codes for a Sharp are 526, 585, 591, 605, 606, 607, 608, 628, 629. Thanks for using Fix Ya.

These are the codes for Sanyo TV'S for this remote. The newer TV codes are at the end so work in reverse order when inputting these codes. Thanks for using Fix Ya.
542, 589, 590, 591, 592, 609

To find the right code first click here.

Next click on the "Remote Controls" section.

Select the type of remote you have (based on the receiver model) to view the remote control users manual.

Hope this helps!

dish network remotes are universal, you can program your receiver, vcr/dvd, telivision and stereo to most remotes. if you need info on this just post again, otherwise i would list your issue under the remote brand

1000,1001,1002,1003,1004
MAGNAVOX and 0000,0001,0002,0003,0004
0057 PHILIPS and 0005,0006,0007,0008,0009

I need codes for my Universal Philips Magnavox remote for a Sanyodvd vcr combo ?