No link t move closer to base try again base

you can contact the service provider.........

The key symbol is supposed to be an antenna.

It can't receive a signal.

There are a few possibilities:

- Too far from base. Move closer.
- Base is unplugged (no power at base station)
- Phone has become unregistered (unlikely).

If you need to re-register the phone, the process will vary depending in the model of the base station and will be covered in the manual.

Well, you could move closer to the base, or try this: RE REGISTER the HANDSET. That works every time when our cordless goes stupid.

Carl

Try unplugging the base unit and plugging it back in again. This is not guaranteed to help but has worked in the past.

place all handsets in the base unit for about 1 minute each. This links the handsets to the base. Sometimes the handsets lose their link to the base unit. If this doesn't work try to call Panasonic tech support for further information, the phones could be defective as well.

It sounds like you may be getting interferance from somewhere. Try moving the base unit to another location. Avoid putting by other electronics. T.V.s, microwaves, and such can mess with the signals. Hope this helps Good Luck!

unplug the base and when you plug it back in
the handset should work

I think you not try one place just try this put in to baladiya(baladiya means waste box)

Your getting this message because the radio portion of the handset or/and base is not communicating with each other. This can be temporary or fatal. You can try re-registering the handset(s) to the base by following the directions in the manual, its fairly easy to do for any model. If that does not work,and you have more than one handset not working with this problem, then it sounds as if your base needs repair or replacing.

you monkeys did not help me i hope you get hit by a bus its called carma