Clean oven burner - Kenmore 79013 Stainless Steel Gas Kitchen Range

call Sears if it is under 1 year old

The clicking sound is from the ignition, but you do not have gas at the burner, I think it could be thermocouple.

How about try reading the manual troubleshooting?

There are a few things to check for. Make sure the electrode ( the small metal piece that the spark comes off from ) is clean and the holes in the burner are clean, use a pin or paper clip to clean out the burner holes and NOT a tooth pick as these can break off and make things worse. Example of a burner. The next thing to check for are theignition switches under the surface control knobs, the switches can twist and break and keep the spark module on and the spark keeps "clicking" even when the burner is light. If every thing looks good, you may have a bad spark module, replace it. Sometimes cleaning can get moisture into the surface switches, try drying them with an hair dryer to see of this will help. Repair and checking tips for surface burners.

The little gas ports maybe blocked on the burners, try cleaning the ports, also on the burners there are 3 or 4 small pin holes for the gas to travel, a small paper clip will remove any debris trapped inside these holes once they are clean the burners should light

To Clean:
IMPORTANT: Before cleaning, make sure all controls are off and
the oven and cooktop are cool. Do not use oven cleaners, bleach
or rust removers.
1. Remove the burner cap from the burner base and clean
according to “General Cleaning” section.
2. Clean the gas tube opening with a damp cloth.
3. Clean clogged burner ports with a straight pin as shown. Do
not enlarge or distort the port. Do not use a wooden
toothpick. If the burner needs to be adjusted, contact a
trained repair specialist.
4. Replace the burner cap, making sure the alignment pins are
properly aligned with the burner cap.
5. Turn on the burner. If the burner does not light, check cap aligment.

1. After self cleaning the range the door won't open
   
2. Amana gas range conversion from NG to propane
   
3. A tip on cleaning the surface grates
   
4. Checking an common oven temp sensor
   
5. Checking an common oven temp sensor: What does an oven temp sensor look like?
   
6. Gas range repair aid - such as, my oven won't work or heat up, which style of gas oven do I have, the glow coil gets red but my oven burner will not light.
   
7. GE gas range conversion from NG to propane
   
8. How to change the oven temp on some common electronic controlled ovens
   
9. How to re-light a surface or oven pilot light
   
10. How to change a common oven glow igniter coil
    
11. How a common gas valve works - click here.
    
12. How Ranges, Ovens, and Stoves Work
    
13. Help for storing an appliance
    
14. Important Disclaimer
    
15. Installing a gas flex line connector
    
16. Maytag, (some) Magic Chef, (some) Jenn-Air gas range surface spark module - new module kit
    
17. Maytag ( Magic Chef - Crosley - Jenn Air ) gas range conversion NG to propane
    
18. My gas range flames die when I turn on more than one thing at a time
    
19. My Range is flashing an " F1 F2 F3 F4 F5 F7 F9 " something, what does this mean?
    
20. My surface burners keep "clicking" even after the burner is light
    
21. Oven door and door hinge help
    
22. Oven temp sensor - how to change helps
    
23. Repair tips and information on surface burner spark modules and igniters
    
24. Some "how to set the self clean" on my range
    
25. Stainless Steel Cleaning
    
26. Surface burners wont work
    
27. This morning I noticed the range top ignition was clicking all by itself every 15-30 seconds
    
28. Test for F1 fault code
    
29. WCI - Frigidaire ( some Kenmore's ) gas range conversion from NG to propane
    
30. WCI - Frigidaire /open burners/ (some Kenmore's) gas
    
31. Whirlpool Direct Spark Ignition (DSI)
    
32. Yes, your glow bar igniter can glow red and still be bad!!
    

 

1. After self cleaning the range the door won't open
   
2. Amana gas range conversion from NG to propane
   
3. A tip on cleaning the surface grates
   
4. Checking an common oven temp sensor
   
5. Checking an common oven temp sensor: What does an oven temp sensor look like?
   
6. Gas range repair aid - such as, my oven won't work or heat up, which style of gas oven do I have, the glow coil gets red but my oven burner will not light.
   
7. GE gas range conversion from NG to propane
   
8. How to change the oven temp on some common electronic controlled ovens
   
9. How to re-light a surface or oven pilot light
   
10. How to change a common oven glow igniter coil
    
11. How a common gas valve works - click here.
    
12. How Ranges, Ovens, and Stoves Work
    
13. Help for storing an appliance
    
14. Important Disclaimer
    
15. Installing a gas flex line connector
    
16. Maytag, (some) Magic Chef, (some) Jenn-Air gas range surface spark module - new module kit
    
17. Maytag ( Magic Chef - Crosley - Jenn Air ) gas range conversion NG to propane
    
18. My gas range flames die when I turn on more than one thing at a time
    
19. My Range is flashing an " F1 F2 F3 F4 F5 F7 F9 " something, what does this mean?
    
20. My surface burners keep "clicking" even after the burner is light
    
21. Oven door and door hinge help
    
22. Oven temp sensor - how to change helps
    
23. Repair tips and information on surface burner spark modules and igniters
    
24. Some "how to set the self clean" on my range
    
25. Stainless Steel Cleaning
    
26. Surface burners wont work
    
27. This morning I noticed the range top ignition was clicking all by itself every 15-30 seconds
    
28. Test for F1 fault code
    
29. WCI - Frigidaire ( some Kenmore's ) gas range conversion from NG to propane
    
30. WCI - Frigidaire /open burners/ (some Kenmore's) gas
    
31. Whirlpool Direct Spark Ignition (DSI)
    
32. Yes, your glow bar igniter can glow red and still be bad!!
    

 

i ceertainly think that there is problem with the burner. as per the working principle of an Oven the ignitor is doin its job so the problem is with the burner please do check it out...

what does f2 mean when I am self cleaning my ge profile oven.