DVD Rubber Band for Load/Eject

You will need to open up both dvd case and dvd player! the rubber type band that turns the wheels to open tray is bad, not tight enough to turn wheels! This rubber type band is located at the front of tray. you might be able to get tray to open by taping the top front of player after you push eject, just not hard enough to bend case.

Most DVD eject system are powered by a small rubber band that can break or just fall off. Going inside the unit will reveal if it has.

Manually pull the door open. If you can see the motor spinning in there it may have a rubber "band" that looks like and O-ring. If that is broken then it can be replaced but it is a difficult manuver with a screwdriver. They tend to dry rot like all rubber parts and fail...

It may have a jam, there is a small pin hole under the tray usually on the right side.. straighten out a paper click and press it in there with some force. This is the manual eject. See if it resumes normal operation after that.

If you want to get the dvd out
you can try this:
First turn of you dvd player at the mains, Then power it up, But the moment it powers up press the eject button a few times so it doesn't start to load. If it doesn't work the first time try it one more time since you may not get the hang of it at first.
then you dvd should eject.
With dvd players like this, corrupt, copied or really scratched dvds may make your dvd player do this.
Regards

if you want to just get the disc out there should be a tiny hole on the front of the drive where you can insert a paper clip firmly to eject the drive.

I would also check the rubber band / cogs by taking a look inside and see if there are any issues.

Also if you reboot do you get the same problem ?

Try the following which i managed to get from POWER ACOUSTIK technical support:

Multi-region for PTID4006T, 406T, 4005, 405, 8006T, 8004, 4003, 5000, 5800, 5300, 530.

1. Turn the unit on and insert a DVD disc. The unit will display LOADING.

2. While the DVD player is LOADING press the following keys:
SET-UP, then press 0, 0, 0, 0 key (0 four times), then ARROW DOWN key (to change the zone to region all 0), then BAND/ENTER key and SET-UP

3. To finish the procedure, push the EJECT key. The disc will eject... Wait and the DVD disc will re-load and play.

FYI - This might damage the unit, but if you really need to get that DVD out then you can try this at your own risk!

Try unpluging the unit, then plug it back in and press the power button and a split second later press the eject button. This all needs to be done quickly otherwise the unit will try to load the disc.

Or

You can try letting the unit load the DVD. When the unit says "Please eject disc. Playback feature may not be avalible on this disc," press the eject button.

Hi
I am trying to set up my LG V782W but have lost my user manual.
Can you help. I need to know how to tune channels and program to record.
thanks
steve

Open up the unit find the load and unload motor on the DVD carriage and turn it manually and this should eject the tray. You may even have to unscrew the carriage to get to the bottom of it to access the load and unload motor.