I have an older life fitness t3 treadmill and it starts and runs for about 5 seconds and then stops and gives me an error 1 message any idea what could cause this?
Error 1 - Start up error. This is caused because the belt was commanded to move and the opto (speed sensor on the motor) has not seen any movement or the belts movement was interrupted prior to it reaching its commanded speed. To fix Verify opto operation in Diagnostics, Motor Test
Mode, Section 2. Verify DC voltage at connector P6 pins 1 and 2. Verify that LED 4 on the Motor Controller flashes as the motor moves. Let me know if you need any more help. Fitness Fix-It
What should the voltage be? 55.6Vdc???
Mine has two green led lights on and the orange light down beside motor flickers for about five seconds then stops and e1 error flashes up and treadmill stops. Can you help
We bought our T3 used tonight and put the two main piece back together, but no manual. Can you tell me what you mean by verify opto operation in Diagnostics Motor Test...means?
×
I have treadmill t50 its says fet error and start up error.
txs
3,661 views
Usually answered in minutes!
Starts running then stops
HOW LONG HAVE IT BEEN WITH YOU? MOST TIME ALL MACHINERY NEED SOME TIME OUT, MEANING THEY NEED TO BE SERVICED PROPERLY BEFORE THEY BECOME ALIVE AGAIN.
×