Got a quote to reapir an FLM-323B. Would not

backligth has no power check the inverter board for any open fusable resistor or open fuse and cold solder

check the fuse

panel defective.caps only repair a power supply issue where the tv wont come on at all.
lines are 90% panel and 10% control pcb
connected to the panel.most control pcb are not
sold separate from the panel.

Even if caps do not look blow, they still can be. Check diodes and resistors on power board. Easy fix if you have patience and time. make sure you replace with a higher voltage, but same cap, resistance values.

Check and replace ALL high value electrolytic capacitors on the power supply board. The Polaroids have known issues with leaky caps in the power supply. It's best to just change them all to prevent future failures.

Yes Tom I did and no it didn't help. I'm back to square one. Sorry!

Check the fuse first next to the cord on the TV

The 2 1000mfd cap that are 10 volts should be replaced with 1000 mfd 16 volts at 105 deg. All the caps need to be high temp and high grade.

Polaroid FLM-323b No power,No led light, checked the fused and the fuse is good?
Can't find any bad Caps? Well I spent some time, well alot of time trying to figure out what's wrong and finally did.
The problem is a diode on the power board location Z9 Part # ( P6KE350A )On some boards it's the diode and the capacitor right next to it part # ( R 331K 1KV )
If this works Please donate Paypal [email protected] anything helps Ive spent well over a weeks time and count less hours trying to figure out what was wrong.I have included some pics to try and help.
Thanks Z28r2fast4u