Duet steam washer -- light for washer cleaning

You can stack, will you be able to reach. Racks can be made to stack any normal washer and dryer.

Possible fault of the level sensor unit, please check the pressure switch, remove and clean.

Test a pressure switch: Click on : http://www.youtube.com/watch?v=HZZ2bDMspj8

The F21 code is a ' drain issue ' --- if you remove the bottom panel from the machine you will see the water pump right there,, just in front of the pump you will see a clean out area,, unscrew counter clockwise and remove the catch screen,,, it most likely has a few things in it ,, clean out - re-install and start the cycle. and the F21 code should be gone AND washer is back up and running.

Sorry, I do not know anythignabout the steam clean.

your drain pump is clooged take of the fromt pannel and clean it

it is an analog pressure sensor failure theres a malfunction with the steamer component detected by the steamer electronic board
check if pressure hose is fixed correctly
check if the airtrap is not blocked
check if the hose is not blocked
hope this helps if this doesnt work write me back

I also need a user's manual too please

It's normal for all washers with a sanitize or tub clean cycle to leave diluted bleach in the dispenser

it may be a problem with the pressure switch clean it out and see if this clears the error code

the panel below the door has 3 screws under the bottom lip of the panel. remove the screws to get the panel off youll see the pump right in front of you. you can unscrew the cap on the pump and remove it to clean out the punp. thats where 99% of clogges are on that washer