Garage door: on calm day panels are weather tight

remove the door trim to get to in side the door. One of the glass tracks will have an adjustment on the lower mount where you can move the track in or out depending what you want. Normally wind the window right down and adjust the track tight against the glass( make sure the glass is in straight). wind the glass up and down a few times to ensure that there are no tight spots Some spray silicon in the tracks helps with the movement of the glass.

Remove rear dooor panels. take inside plastic loose at the bottom and half way up the door.take and tuck in the bottom of door...this does take in account the plastic is still on the door. Now take another piace of plastic and seal it against the door frame . Then reinstall door panel.

i have bent many doors to make them fit.Roll down window and door should bend fairly easly,keep checking with that buck

well the there are lots of possabilities but the most likly one is that there are shadows or pieces of debris that are on a laser detector or the chain that pulls the garage door is being heated while it is frozen which could change the signal on the closer. or you need a theremal cover on ur opperator system for the opening and closing on the door.... google always helps

need to get a body man to adjest it

Hi, This is usually caused from a bad door seal. Checkand make sure the door is sealing tight on all sides. Also make sure the little switch near the controls is set for humid days.
Please let me know if I can assist you further.

Vic

open the door and look at the edge of the door that closes against the car (kinda wide and it is the area that seals against the weather stripping) you'll see a little oval hole with a black piece of metal bearly sticking out... just push it to the other side of the oval hole.

I have the same problem. Just talked to a friend that's a great appliance repairman. he said I have to remove the panel in the back inside of freezer and there is a drain that gets clogged up, a little hole or tube.
clean that and should work fine and stop leaking. I haven't had time yet, but this weekend I'll do the deed. Hopes this helps ya!

Depending upon your model it could either be a sagging door hinge (requires replacement) or the fridge my not be level. If you remove the toe-kick panel there will be a couple of bolts which are used for leveling ( they should be indicated as such or shown in your owners manual). Alternately there may be screw type legs which are used to level your fridge.

The seal should improve once the doors are properly aligned.

first guy has the mounting screws tp tight or the wire is preventing wall station for sitting flush against wall....second guy check your safety eyes...