Code de turn unit on and error code de apears after a clicking sound.

LOTS of fault codes here, but NO "E90"

BOSCH Side by Side Refrigerator Error Fault Codes Error Codes

Then there is this:

"Most of the times when the F:09 Error code apears on a Bosh Dryer is due to the thermal cut off being triggered, you can correct this issue by simply disconnecting the power to the unit and removing the back panel of the machine where you will find the button to be red. simply press it in and test the unit... if this doesn't resolve the issue, most likely your belt snapped off and would need to be replaced."

My Bosch dryer has error code 09 What does that mean

And if THAT is not enough, WATCH THIS!

Bosch Condensing Dryer F09 Error

Anthony

SC 542 Fusing temperature warm up error.Fusing lamp defective,poor fusing unit connector,thermistor warped or broken,thermostat has tripped,power supply defective.After verify the componenets try reset the error.Enter in service mode:Press the yellow key and press 107 and keep pressed the stop key 3 second.Touch the SP window on screen open the front door and turn OFF the copier.Wait 1 minutes ,close the front door and turn ON the copier.If the error code persist change the upper fuser roller and the thermistors.

dE for LG does the spring of latch hook actuate? no> fix door latch Yes> is there clicking sound once or twice when the start/pause button is pressed to start the cycle? No> check door switch and main PWB Assemblyhope that helps..
OE is Drain Error.

maybe the fan for cooling the projector has a problem, you can bring it to the service center coz its not easy to replace those fan, thanks

You will need a new door llock switch.
to change it you will need to loosen the front bellow by removing clamp, unscrew the twwo scrwes holding the switch then unplug wires to switch and re-install.

HI. This is a Door Open error code.

Here are 4 reasons for this issue:

* The Door may not be all the way closed
* Loose electrical connections at door switch and pwb assembly.
* Door switch assembly is out of order
* Gasket on door may be creased in


Ok. You have stated that the unit is attempting to lock the door, but it is not locking. There are two click, then the error code illuminates the DE code. This is common when the control cannot initiate a door lock sequence. The cause will be a failed door lock mechanism, and it will require you to replace this mechanism asap, if possible. The actuator has failed. Replacing the door switch mechanism, will correct this issue.

Check speaker connections and wires and make sure all wires are plugged properly. If problem still exist then unplug speaker one=by-one and test home theater to determine what speaker is causing Protect error.

3300 shows me this error E000100-002

check sound drivers in device manager

run-->devmgmt.msc

In this case, IT support staff corrected. Not sure what solutions or actions they took.