My mitsubishi hdtv1080 is stuck on camcorde, how can I get it off?

Download the service manual to your set. It will have all details. blinking of standby light is fault codes. These codes and repair proceedings will be detailed in the service manual.

The tv power supply board it is dead.That the board where the power a/c cord plug into it.Tries websites like Shopjimmy.com,Ebay.com to buy a whole refurbish power supply board for the replacement.

This is due to bad capacitors in the power supply. You can try to replace them yourself or call Mitsubishi for help. Check AVS forum with your model number for tips on a self repair

The screensaver is setup in the control panel of the computer. Right click on the desktop and go to properties, Then go to screensaver and set it up there.

ITS A 2003 HD MODEL,REPAIRING WOULD COST 250.00-350.00 WHICH SEEMS A LOT BETTER THEN BUYING A NEW TV. I RECOMMEND THE HIGHER REPAIR AND GET THE ORIGINAL MITSUBISHI IC'S.

You can try adjusting the convergence which will be in the Advanced Menu of your TV. If it will not adjust properly then you need to have a qualified technician repair the set.

you gonna need some technical skills to replace the parts that are bad on your tv,but anyway check the power supply first,look for some swallen capacitors.and replace them that is going to be your first step.

thanks.
[email protected]

You most likely have a fault in the defelection circuitry that is causing this. A repair is needed, none-the-less....accordianman

Pull out the power cord from the outlet for about one minute and then replug it. The blinking will restart for about a minute or less and then the set will turn itself off. You will then be able to turn it back on in the usual way with the remote or power switch.

I believe this is caused by a power surge or a momentary power outage.



SG

picture decides to go out , sometimes for 2 or 3 days then turns back on its own.....what could this be?