GA-8SIML will not post or boot. Removed all PCI

Make reset for motherboard-

Put just the ram back into the motherboard, the pc will not boot without processor, ram and graphics pluged into the board, check this, if it will still not boot and you still get 3 beeps its a memory(ram) problem, and you will need to replace the memory stick.

as been have ssen in picture and specs of your mainboard you have a integratd vga vard and a agp slot. so solution may be this
with old integrated vga open bios program go to disply and choose pci input first. this enable you to boot from pci slot with a new vga save setting switch of computer put on new pci vga and try.
if no option to activate pci init first , sorry you can not boot any vga from pci , but only from agp slot.

Three beeps for that bios is a memory error.Are you sure it's not a memory issue? Did you clear the CMOS and try to boot up again?

Just because it doesnt beep doesnt mean the vid is not gone

place board on a non metal surface hooked to
monitor
keyboard
mouse
powersupply UNPLUGGED RIGHT NOW
cpu with heatsink and fan attached
ram

plug power supply in (will not shock you just dont lick it ok)
if board does not come on take a small flat head screw driver look at where the power wire would slide on cross those two pins should come on. again will not shock you.

still no video try pci (most basic video mobos support) card
still no video could be cpu I have had several of these be bad caouse no video also
try anouther cpu same setup
still no vid mobo shot sorry

While booting BOIS goes for POST check for detecting the all the hardware .

Disconnect all the connection to DVD, HDD, FDD from MOBO.
Rmove all RAM and start the ssytem from testing RAM Serviceability. If you listened a long intermittent beep place a single pices of RAM in MOBO ( repeat test with other RAM also).

Other wise your video card is unserviceable, if you have any addon plugins like NVIDA graphics card you can check

no beeps, indicates you have faulty CPU or mainboard.

• remove all components even RAM and CPU.
• insert only CPU and Speaker (without RAM or any other componet).
• Boot and try to hear, there must be long beep for missing RAM, if not then try to re-insert the CPU or change the CPU/Mainboard.

Thanks and Good Luck
Iqbal

Does your System freezs before booting up? Try setting the BIOS to defalut. There could be a software related problem also. Try reinstalling the windows.Your hardware seems well match for the entire system(Provided all are ok) It was not clear where the system freezs.

can you get into the bios?

you should be able to press F2 or Del on boot up to get into the bios, but you should replace the battery first then set everything up as the cmos has obviously lost it's saved settings because the battery is flat.