Hotpoint Aquarius WMA 32

Have you been wiping the glass off in the door. A buildup of detergent crust on the bottom will cause the seal to weep.

Unplug for 30 minutes to reset the control board. If problem persists, it is likely that the control board will need to be replaced.

old belt may be streched replace it and it should be ok first make sure there in no water or oil leaking onto the pulley wheel thankyou

Hiya,
some machines have a filter at the front of the machine it will be right down the bottom behind the trim this trim normally just pulls to open & if so you will see a small circle if you unscrew that some water will come out & if blocked will have some stuff in that you can remove,

Hope this helps

Possibly Pump blocked. or impeller broken. without taking a proper look but sounds the obvious.

is the drain pipe installed properly and have you cheaked the water is properly on and the water intake filter cleaned hope this helps.

inside hose at back ,take back lower panel off black hose filter inside.

hiya
it could be a number of problems which are very common on the entire wma range.
1, drum bearings are really poor in these.
2, concrete block tapping, sometimes the bracket n the drums snap.
3, motor bracket snapped causing tapping.

i've found the plastic drums seem to be quite weak on the wma range to be honest so will more than likely be one of the above.

hope this helps

Close your faucet valve & unscrew your hoses to check screens on hoses & machine. Clean out well. Refit, check for leaks. Water shd be in good pressure. If this is not the problem change your inlet valve, it is easily done. Suggestion: use powders for front loaders.

hi on the model before this one the wma series the flashy pre wash light is a faulty water inlet valve these mashines are allmost identical inside so check that,first check that you have the hot/cold pipes on the right way around hope this helps