The dryer will not start when you push the switch. Have checked the plug and power at the box. It sounds like the clock on the setting is working, but nothing happens when you push the button

That model number is for a washer.

Hi,

There can be many reasons why your dryer will not start or turn...

The most common causes are the belt breaking or jumping off, or the motor goingbad...

Here are a couple of tips that I wrote will help you to figure out why yourdryer will not run...

Dryer Repair - The Dryer is not Turning

Dryer Repair - The dryer will not start


heatman101


[
[

Check belt, timer and motor

Check the continuity of the door switch. If it does not work like it should the dryer will not start

Hi,


Press and hold start button for 4-5 seconds.Make sure that the start button has been fully pushed down or turned far enough to activate the dryer.

After that plug something else into the same outlet. If it works, you know you have power to the dryer. If it doesn’t work, you’ll need to check for any blown fuses or tripped circuit breakers.


If the power is there, you need to check door switch, thermal fuse, thermostats, and start switch to see if one of these is faulty.
Make sure that the control settings are appropriate, and that any buttons are fully depressed.


Good Luck and have a nice day.

you may have a bad start button or a bad door switch these are the first thing to check out.if those check ok then you may have a bad motor.i hope this helps good luck

Sounds like the motor is gone. Try opening the door and pushing the door swithch inside the dryer door cavity.This may take two people but while holding the door switch, push the start switch and turn the dryer drum at the same time.(in a clock direction) If the dryer starts it means the moter is shot.

This could be your start switch has gone out. That is what it sounds like to me.

Contact us at:


http://www.fixya.com/repair/d499389-accurate_appliance_repair_service for service information and parts.
We answer our customers calls from 7 AM until
9 PM CST so give us a call when you need us.
Thanks, Ella

Check your GFI switch

when you switch the unit on make sure that you hear two clicks, this will tell you whether the protection relay is working. Should you hear the two clicks this will indicate that the audio ic`s are working. There are fuses inside the main component box, four on the transformer. Let me know the outcome


craig:)