Epsom RX420 all in one

Print quality is good, b&w copy is good. When i make a color copy the machine makes blue lines or bink lines. This is a brand new c452.Scan to PC is ok, print its ok only copy. Lines are vertical.

hp laserjet 3020 All in one printer

Hi there, As it sounds its a dirty scanning glass. Open the top of the scanner so that you can see the scanning glass.. If your standing in front of it you will see on the left hand side a strip of thinner glass.. Take a damp cloth (better cloth with spirits/surgical alcohol) and clean the both the small and the large scanning glass. These lines normally cause if the glass is dirty. Especially if your using the document Feeder. As a lot of time wet ink or typex or correction fluid gets stuck on glass which will cause these lines.
Hope it helps
Regards,

You will need to access your printer settings. The option could be hiding under an advance tab. Look for a default menu and reset the defaults.

Go to that document and clink on properties. You will find that the right hand margin is set too far left to accommodate an 8x11 document.

have you set the page setup in document is same with page setup at print setup. Some new epson printer use paper sensor to measure the paper width. If page setup wider than actually paper inserted, the printer will print only half page. example : Your document 10 cm wide, page setup 20 cm, and you insert 10 cm paper wide. It will print only half of 10 cm, 5 cm.

Refer to this free online website for dell

http://support.dell.com/support/topics/global.aspx/support/dsn/en/tree?treeid=4F006C0C8C044866841FEF0842919C1D&~ck=gp&servicetag=

Please tell me if you need more info

Clean the ADF roller and the far left hand side of the glass, the small strip outside the 'main' panel.

Another post suggests that you printer is dead -see (http://www.fixya.com/support/t354202-epsom_rx_425_just_prints_half_page) but I've had the same problem - things seem to be ok after I reset to the defaults in the main page of the printing preferences.

Click Start - Printers and faxes

Right click on the printer icon and select properties.

Click on Advanced tab. Enable the option print directly to printer.

Click apply n OK.

Check for the result.