It cant get gas and the off and on switch is busted. What can I do to fix this problem?

that is illogical. the issue has to be with the gas tank repair.
u need to get the air out of the gas line, or u missed replacing some wiring - but since the motor runs i'm going with air.

fix what part ? Is your check engine light lit ?

unless the ratchet under the cap is busted try pushing down on the cap as you are unscrewing it ( same as a child proof cap on a bottle)

make sure radiator fan is working and make sure radiator fan switch is good and check thermostat too.

try priming the system it just might have air

Your confused

If you have a leak, you have to repair
the hose assy etc

I am familar with classic tool design
but not the cut switch.
Explain that to me

You say hose busted,on what,your refrigerant
gauge manifold

hi there, in that case totally busted,there are motor protection should be checked if this are open. 1.check the source of current on circuit breaker using multi tester.if there is source or voltage supply.if nothing voltage supply reset breaker. 2.if current is available on circuit breaker check the overload protection relay if there is reset over load protection.try to power on. 3.check the pressure switch if open,it always normally close meaning the contact-or is closed if busted,replace pressure switch. 4.if still not work pull out motor and check this to electric motor service center. 5.check also the mechanical parts by cracking flywheel pulley of the compressor.if no rotation on flywheel pulley have check on this.if no motion it affects the motor protection. fix my rate and have a nice day thanks a lot.

Your best bet is to invest in a Chilton book on your specific vehicle. It will give you pictures and exact directions on how to do this. All Checkers or what ever auto service center you have in your town will carry them. Just a useful warning though - don't buy knock off's just buy the Chilton. Good rule of thumb ALWAYS put it in the same way you took it out. Good luck!!!!

they do make pcmcia usb ports. may be easiest way to fix...

I know it sounds stupid but a lot of people just forget to turn on the wireless switch.

You may want to check first if the router is being picked up by other computers just to eliminate the possibility of a busted router. If no other computers can pick up your Router's signal then it's the router that you need to replace. If other computers can pick up your router's signal, then it's the computer's wireless card that's busted.