Yellow Hue when color copying

that's got t o do with personnel preference and room lighting , but as a general rule adjust color hue's till the edges of a white color object on screen has just lost its primary color edge

the older projection TV's actually have voltage numbers for the service tech to adjust them too , but im not remembering seeing any in the LCD manuals

check whether the printer is in proper mode or not

You can only remove it by bleaching it. Usually though, we merely neutralize yellow by applying a permanent tint, demi-permanent color, semi-permanent rinse, or a colored shampoo in a complementary color, that is a hue that is opposite yellow on the color wheel. The hue most often used is violet.

Try dabbing the cartridges on a paper towel, if you don't see a yellow line, the yellow is just empty, many have had the same complaint, new cartridges with no yellow inside.

YOUR COLOR BULB IS GOING OUT GOT TO GET A NEW ONE.

Hi There,

print out a page from windows paint program of cyan, magenta, and yellow. see which colors are incorrect. that will help you get closer to the problem area.

the drum also may not be screwed in all the way. remove it, and try putting it back in again.

Check you HD inputs or source. Sounds like the red stream is missing; maybe a loose cable.

1. try to connect to another computer . if it is fairly good then it must be your computer is having a problem.may be your video card problem.

1)Please verify your model # from back of set......

2)Reduce the color to minimum or tune in a black & white chan.
you should see gray, not yellow hue

3)Remove lower front grill cover & access panel.....locate the
focus / screen control block...turn blue screen control slightly
CW......red,green and blue must mix to equal gray

4) reset color to normal level.......reassemble

You need to align the cartriges. If you have the HP software installed on your machine, you can just open that and click on the align button. If not here is the link to download the software:

http://h20000.www2.hp.com/bizsupport/TechSupport/DriverDownload.jsp?&lang=en&cc=us&pnameOID=446154&taskId=135&prodTypeId=18972&prodSeriesId=446153&lang=en&cc=us

Just select your operating system and then download the North America/Western Europe full software solution under software. This should allow you to align your cartiges. Just follow the instructions when aligning. Hope this helps you out!